Viewing Unit History

The information below is relevant from 27/10/2014 to 27/10/2014
Click Here to view current information

ENTM12005 - Computer Aided Drafting and Design (Mechanical)

General Information

Unit Synopsis

This course extends the knowledge and skills developed in Computer Aided Drafting. Students obtain relevant standards, manuals and handbooks, an d research product information relevant to a project, work with engineers design instructions and project data, and apply this information to prepare 3D models, detail and assembly drawings and project and documentation. The course presents methods of detailing tolerances, welds, machining and surface finishes and production of pipe layouts and fluid power schematics. It outlines office procedures for managing project information and documents and roles and responsibilities of members of engineering design teams. Students demonstrate professional teamwork and communication and support collaborative learning. Distance education (FLEX) students are required to have access to a computer capable of running computer aided drafting software, and to make frequent use of the Internet.

Details

Level Undergraduate
Unit Level 2
Credit Points 6
Student Contribution Band SCA Band 2
Fraction of Full-Time Student Load 0.125
Pre-requisites or Co-requisites

[ENTG11001 or ENTA12011 or ENEG12002 or ENEG12006]

Important note: Students enrolled in a subsequent unit who failed their pre-requisite unit, should drop the subsequent unit before the census date or within 10 working days of Fail grade notification. Students who do not drop the unit in this timeframe cannot later drop the unit without academic and financial liability. See details in the Assessment Policy and Procedure (Higher Education Coursework).

Class Timetable View Unit Timetable
Residential School No Residential School

Unit Availabilities from Term 3 - 2024

There are no availabilities for this unit on or after Term 3 - 2024

Attendance Requirements

All on-campus students are expected to attend scheduled classes - in some units, these classes are identified as a mandatory (pass/fail) component and attendance is compulsory. International students, on a student visa, must maintain a full time study load and meet both attendance and academic progress requirements in each study period (satisfactory attendance for International students is defined as maintaining at least an 80% attendance record).

Assessment Overview

Recommended Student Time Commitment

Each 6-credit Undergraduate unit at CQUniversity requires an overall time commitment of an average of 12.5 hours of study per week, making a total of 150 hours for the unit.

Assessment Tasks

This information will not be available until 8 weeks before term.
To see assessment details from an earlier availability, please search via a previous term.

This is a graded unit: your overall grade will be calculated from the marks or grades for each assessment task, based on the relative weightings shown in the table above. You must obtain an overall mark for the unit of at least 50%, or an overall grade of ‘pass’ in order to pass the unit. If any ‘pass/fail’ tasks are shown in the table above they must also be completed successfully (‘pass’ grade). You must also meet any minimum mark requirements specified for a particular assessment task, as detailed in the ‘assessment task’ section (note that in some instances, the minimum mark for a task may be greater than 50%).

Consult the University's Grades and Results Policy for more details of interim results and final grades

Past Exams

To view Past Exams,
please login
Previous Feedback

Term 1 - 2014 : The overall satisfaction for students in the last offering of this course was 66.67% (`Agree` and `Strongly Agree` responses), based on a 50% response rate.

Feedback, Recommendations and Responses

Every unit is reviewed for enhancement each year. At the most recent review, the following staff and student feedback items were identified and recommendations were made.

Source: Student
Feedback
Industry is moving to use of SolidWorks rather than AutoCAD 3D.
Recommendation
Investigate a change in the recommended software to ensure course remains inline with industry practice.
Action Taken
In Progress
Unit learning Outcomes
This information will not be available until 8 weeks before term.
To see Learning Outcomes from an earlier availability, please search via a previous term.